Same-week pole sets ยท Sacramento, CA

Spot Cooler Rental

Portable spot coolers for hot buildings, server rooms, events and crews working through Sacramento summers. Call (916) 237-3494 for a free estimate.

Quote for Spot Cooler Rental

A dispatcher calls back during office hours, 7am to 7pm daily.

Spot coolers lined up outside a large Sacramento-area building, orange ducts feeding cold air inside

Portable Cooling Through a Sacramento Summer

A spot cooler is a self-contained air conditioner on casters. It pulls in warm air, blows cooled air out through a flexible duct to where people or equipment need it, and exhausts the heat through a second duct. Smaller units plug into a standard outlet. Larger ones need 208 or 230 volt power, and the biggest run on three-phase service.

Sacramento summers are the reason this service exists for us. Afternoon highs in July and August regularly pass 100 degrees, and a steel building with no working HVAC can get much hotter inside. Crews hanging drywall, installing flooring or finishing a tenant space slow down or stop. Spot coolers bring the work area down to a level where people can keep going.

Cooling is also a cure issue. Flooring adhesives, paints and some coatings have temperature ranges set by the manufacturer, and a space that stays above them can delay the job. Spot coolers help hold the space in range. Big jobs may need more power than the building can supply, and a Towable Generator Rental unit can run a bank of coolers on its own.

Cooling Set Up Around the Space You Have

A spot cooler only works if the heat it removes goes somewhere else. We plan the exhaust duct to a ceiling plenum, a window, a door panel or the outside, and we plan condensate drainage so water does not end up on the new floor. Getting those two details right makes more difference than the size of the unit.

The Delta breeze helps. On many summer evenings cooler air moves in from the southwest, and buildings can be flushed out overnight with fans before the coolers take over in the morning. We work that into the plan for long rentals. If the building has no power yet, the cooler can run from a Temporary Power Poles panel or a generator, and our Sacramento Valley temp power rentals crew sets up both.

Where Spot Coolers Earn Their Keep

Most spot cooler calls come in once the first heat wave hits. These are the setups we see most often around Sacramento.

Tenant Improvements Without HVAC

Interior build-outs often start before the rooftop units are installed or working. Coolers ducted to each work zone keep drywall, paint and ceiling crews productive.

Server and Electrical Rooms

When a building's cooling goes down for replacement, a server room or electrical room can overheat in hours. A spot cooler sized to the heat load keeps equipment running.

Warehouse Work Areas

Large distribution buildings along I-5 and Highway 99 are hard to cool as a whole. Spot coolers aimed at a packing line or assembly area cool the people without cooling the whole building.

Event Tents and Green Rooms

Outdoor events in summer need cool spaces for performers, staff and first aid. Coolers ducted into tents or trailers make those areas usable through the afternoon.

How We Plan a Spot Cooler Install

  1. Measure the Space and Load

    We ask how big the space is, how tall the ceiling runs, how much sun it takes and what people and machines are inside. That gives us the cooling capacity you need.

  2. Plan Exhaust and Drainage

    We find a place for hot exhaust to leave the space and decide how condensate will be handled, either with a pump to a drain or a tank that gets emptied.

  3. Confirm the Power

    We check the voltage and circuit size for each unit. If the building cannot carry the load, we bring a generator or tie into the temp pole.

  4. Deliver, Duct and Start

    Units are rolled into place, ducts are run and secured, and each cooler is started and checked for cold air at the outlet and a working drain.

  5. Check In and Pick Up

    On longer rentals we check filters and drainage. When the permanent HVAC is running, we pull the coolers and ducts out.

Spot Cooler Sizing and Setup Details

Power Requirements by Size

Small coolers run on a standard 120 volt circuit. Mid-size units usually need a dedicated 208 or 230 volt circuit. The largest need three-phase power. Matching the unit to the available power is part of the quote.

Condensate in Dry and Humid Weeks

Sacramento summer air is usually dry, but humid days still happen, and the cooler pulls more water out of the air on those days. A condensate pump to a drain avoids overflowing tanks on a weekend.

Heat Rules for Crews

California has heat illness rules for workers outdoors and indoors. Spot coolers help an employer keep indoor work areas cooler, along with water, rest and shade. Your safety plan sets the requirements, and we help with the cooling side.

Spot Cooler Rental: Questions From Sacramento Crews

How big a spot cooler does a room need?

It depends on room size, ceiling height, sun on the walls and roof, and the heat from people and equipment. We ask about each of those and recommend a size or a set of units.

Where does the hot air from a spot cooler go?

The exhaust duct sends it out of the space, usually into a ceiling plenum, through a window or door panel, or straight outside. If the hot air stays in the room, the cooler cannot keep up.

Can spot coolers run on a temp power pole?

Smaller units can run from standard receptacles on the pole. Larger units need a 208 or 230 volt circuit, and a bank of coolers may need a generator. We check the power before delivery.

Do spot coolers work in a large warehouse?

They work best when aimed at specific work areas rather than the whole building. We duct cold air to packing lines, workstations or break areas so the people get the benefit.

How early should I book spot coolers before a Sacramento heat wave?

As early as you can. Demand jumps the moment the forecast shows a string of 100 degree days, and the larger units go first. If your job will have crews inside an unconditioned building between June and September, reserve the coolers when you schedule the interior work.

Other equipment we deliver

  • Temporary Power Poles

    Meter-ready temp poles set, wired and grounded for SMUD, PG&E and Roseville Electric hookups.

  • Job Site WiFi

    Cellular WiFi for site trailers and plan tables, set on a mast and powered off your temp pole or generator.

  • Construction Camera Systems

    Pole-mounted cameras that watch copper, tools and stored material overnight, with remote viewing on your phone.

  • Towable Generator Rental

    Trailer-mounted diesel generators sized for job sites, shutdowns and events, delivered and connected by our crew.

  • Light Tower Rental

    Diesel and LED light towers for early pours, night shifts, winter evenings and event parking lots.

Give us the site address, what has to run and the day you need it. We will put a crew on the board.

Call (916) 237-3494